Vivitek H118x Series Uživatelský manuál

DLP Projector—User’s Manual – 1 – GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included:

DLP Projector—User’s Manual Views of Projector Parts Front-right View ITEM LABEL DESCRIPTION SEE PAGE 1. IR receiver Receive IR signal from rem

DLP Projector—User’s Manual Top view—On-screen Display (OSD) buttons and LEDs 162345127891011 ITEM LABEL DESCRIPTION SEE PAGE1. MENU Opens and ex

DLP Projector—User’s Manual Rear view 1210345 6 7 8 9111213141516 ITEM LABEL DESCRIPTION SEE PAGE 1. AC IN Connect the POWER cable 11 2. 3D SYN

DLP Projector—User’s Manual – 5 – Note: If your video equipment has both S-VIDEO and RCA jacks (composite video) connect to the S-VIDEO connector. S

DLP Projector—User’s Manual Bottom view ITEM LABEL DESCRIPTION SEE PAGE 1. Ceiling support holes Contact your dealer for information on mounting

DLP Projector—User’s Manual Remote Control Parts 123456789101112131415161718192021222324252627282930 Important: 1. Avoid using the projector with bri

DLP Projector—User’s Manual — 8 — ITEM LABEL DESCRIPTION SEE PAGE 1. Power OFF Turns the projector off 11 2. HDMI 2 Displays the HDMI 2 source

DLP Projector—User’s Manual – 9 – Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not nec

DLP Projector—User’s Manual Inserting the Remote Control Batteries 1. Remove the battery compartment cover by sliding the cover in the direction of t

Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights r

DLP Projector—User’s Manual – 11 – SETUP AND OPERATION Starting and Shutting down the Projector 1. Connect the power cord to the projector. Connect

DLP Projector—User’s Manual 5. When the “Power Off? /Press Power again” message appears, press the POWER button. The projector turns off. Caution: 1

DLP Projector—User’s Manual Setting an Access Password (Security Lock) You can use the four (arrow) buttons to set a password and prevent unauthorized

DLP Projector—User’s Manual 5. You can use the cursor buttons ▲▼◄► either on keypad or IR remote control for password entry. You can use any combinat

DLP Projector—User’s Manual Adjusting the Projector Level Take note of the following when setting up the projector: • The projector table or stand sh

DLP Projector—User’s Manual Adjusting the Zoom, Focus and Keystone 1. Use the Image-zoom control (on the projector only) to resize the projected ima

DLP Projector—User’s Manual – 17 – ON-SCREEN DISPLAY (OSD) MENU SETTINGS OSD Menu Controls The projector has an OSD that lets you make image adjustmen

DLP Projector—User’s Manual Setting the OSD Language Set the OSD language to your preference before continuing. 1. Press the MENU button. Press the cu

DLP Projector—User’s Manual OSD Menu Overview Use the following illustration to quickly find a setting or determine the range for a setting. ImageSett

DLP Projector—User’s Manual Image Menu Attention ! All of display mode parameters when changed will be saved to user mode. Press the MENU button t

DLP Projector—User’s Manual — ii — Important Safety Information Important: It is strongly recommended that you read this section carefully before usin

DLP Projector—User’s Manual Computer Menu Press the MENU button to open the OSD menu. Press ◄► to move to the Image menu. Press ▲▼ to move to the Comp

DLP Projector—User’s Manual Advanced Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Image menu. Press ▼▲ to move to the A

DLP Projector—User’s Manual Color Manager Press the Menu button to open the OSD menu. Press ◄► to move to the Image menu. Press ▼▲ to move to the Colo

DLP Projector—User’s Manual Settings 1 Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Settings 1 menu. Pr

DLP Projector—User’s Manual Audio Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 1 menu. Press ▼▲ to move to the Audio m

DLP Projector—User’s Manual Advanced 1 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 1 menu. Press ▲▼ to move t

DLP Projector—User’s Manual 3D Setting ITEM DESCRIPTION 3D Press the cursor ◄► button to enter and select different 3D mode. 3D Sync Invert Press

DLP Projector—User’s Manual Advanced 2 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 1 menu. Press ▲▼ to move t

DLP Projector—User’s Manual Settings 2 Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Settings 2 menu. Pr

DLP Projector—User’s Manual Status Press the cursor ▲▼ button to move up and down in the Settings 2 menu. Select the Status menu and press Enter or ►

Preface Projector Installation Notice ¾ Place the projector in a horizontal position The tilt angle of the projector should not exceed 15 degrees, no

DLP Projector—User’s Manual Advanced 1 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 2 menu. Press ▲▼ to move t

DLP Projector—User’s Manual Lamp Hour Reset Please refer to Resetting the Lamp on page 37 to reset the lamp hour counter. — 32 —

DLP Projector—User’s Manual Advanced 2 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 2 menu. Press ▲▼ to move t

DLP Projector—User’s Manual Source Filter Press the ENTER button to enter the Source Filter sub menu. ITEM DESCRIPTION VGA Press the cursor ◄► butt

DLP Projector—User’s Manual – 35 – MAINTENANCE AND SECURITY Replacing the Projection Lamp The projection lamp should be replaced when it burns out. It

DLP Projector—User’s Manual 2. Remove the lamp compartment cover. 3. Remove the three screws from the lamp module. 4. Lift the module handle up. 5

DLP Projector—User’s Manual Resetting the Lamp After replacing the lamp, you should reset the lamp hour counter to zero. Refer to the following: 1. P

DLP Projector—User’s Manual — 38 — Cleaning the Projector Cleaning the projector to remove dust and grime will help ensure trouble-free operation. Wa

DLP Projector—User’s Manual Using the Kensington® Lock & Using the Security Bar Using the Kensington® Lock If you are concerned about security, a

DLP Projector—User’s Manual — 40 — TROUBLESHOOTING Common problems and solutions These guidelines provide tips to deal with problems you may encounter

DLP Projector—User’s Manual — iv — Verify Installation Location ¾ To supply power, the 3-blade (with earthing lead) socket should be used to ensure p

DLP Projector—User’s Manual – 41 – LED Error Messages ERROR CODE MESSAGES POWER LED GREEN LAMP LED RED TEMP LED RED System Initial Flashing OFF OFF Re

DLP Projector—User’s Manual — 42 — 1. Position the projector so it is as perpendicular to the screen as possible. 2. Use the Keystone button on the

DLP Projector—User’s Manual – 43 – 3. Check the audio cable connection. 4. Test the source audio output with other speakers. 5. Have the projector

DLP Projector—User’s Manual — 44 — HDMI Q & A Q. What is the difference between a “Standard” HDMI cable and a “High-Speed” HDMI cable? Recently, H

DLP Projector—User’s Manual – 45 – SPECIFICATIONS Specifications Model H1180HD H1185HD Display type TI DMD 0.65" 1080p Resolution 1080p 1920x1080

DLP Projector—User’s Manual Projection Distance vs. Projection Size Projection Distance and Size Table H1180HD / H1185HD IMAGE DIAGONAL （INCH） IMAGE

DLP Projector—User’s Manual – 47 – Timing Mode Table SIGNAL RESOLUTIONH-SYNC ( KHZ ) V-SYNC( HZ ) COMPOSITES_VIDEO COMPONENT RGB (ANALOG) HDMI (DIG

DLP Projector—User’s Manual — 48 — SIGNAL RESOLUTIONH-SYNC ( KHZ ) V-SYNC( HZ ) COMPOSITES_VIDEO COMPONENT RGB (ANALOG) HDMI (DIGITAL)1280 x 1024

DLP Projector—User’s Manual Projector Dimensions TEMP POWER LAMP – 49 –

DLP Projector—User’s Manual — 50 — REGULATORY COMPLIANCE FCC Warning This equipment has been tested and found to comply with the limits for a Class B

Preface Power Safety ¾ Only use the supplied power cord. ¾ Do not place anything on the power cord. Place the power cord where it will not be in the

DLP Projector—User’s Manual – 51 – APPENDIX I RS-232C Protocol RS232 Setting Baud rate: 9600 Parity check: None Data bit: 8 Stop bit: 1 Flow Contro

DLP Projector—User’s Manual — 52 — Command Group 01 ASCII HEX Function Description Return ValueVXXG0101 56h Xh Xh 47h 30h 31h 30h 31h 0Dh Get Brig

DLP Projector—User’s Manual – 53 – Command Group 03 ASCII HEX Function Description Return Value VXXG0301 56h Xh Xh 47h 30h 33h 30h 31h 0Dh Get Scal

DLP Projector—User’s Manual — vi — Main Features • Lightweight unit, easy to pack away and transport. • Compatible with all major video standards in

Preface –vii – Table of Contents GETTING STARTED.......

DLP Projector—User’s Manual — viii — SPECIFICATIONS.........................